Skip to content

Latest commit

 

History

History
44 lines (38 loc) · 2.29 KB

CHANGELOG.md

File metadata and controls

44 lines (38 loc) · 2.29 KB
Raw

Changelog

All notable changes to this project will be documented in this file.

[Unreleased]

[1.0.5] - 2019-12-03

Changed

  • Remove sending stop commands for laser and tec when user try to close app or disconnect
  • Bug fix with settings default state of device.

[1.0.4] - 2019-11-15

Fixed

  • Signed commands issue. Sign wasn't shown
  • Fix change temoearute symbol bug. Units doesn't change when user change Celsius\Farenheit units, only values recalculates before.
  • Menus and buttons are blocked too when connection is lost
  • "keep checkboxes" option is enabled by default
  • Calibration limits minValue and maxValue are double (instead of int) now
  • Software didn't check tec status when user tried to close a software. It is checked now.

[1.0.3] - 2019-10-29

Added

  • Showing suestion message about laser state if user tries to close an app or disconnect when the laser on
  • Checkboxes saved when user change its value and load when user connects to device

Changed

  • Refactoring of some issues
  • Optimization of the algorithm for receiving data. Fix bug with clearing the buffer the received data timeout
  • Fix bug with the lack of responses from the device when connecting.

[1.0.2] - 2019-08-22

Added

  • Add abilitiy to save state of device by one click and then load it again. It makes due to device status not saved when the device restarted.
  • Safety fix. If the laser started and you exit the software it will try to stop laser.

[1.0.1] - 2019-04-20

Changed

  • Change some syntax for limits into xml config.
  • Add SignedCommand subclass for Command. It uses for display signed values.
  • When user stop the device, the software use an extra delay. It didn't occure when user stop the TEC. This problem was fixed. TEC stopping is also going with extra delay.

Fixed

  • incorrect display of current value due to divider error. Change xml config. Dividers use only for "command" tags.
  • Each time you connect to device, if it returns a "common ID", user is prompted to select a custom device model.
  • Limit settings window is working correctly now. Fix bug with sending new limits without code: user could send a new limit like "P ".
  • TEC button did not show the TEC status.
  • Fixed an issue with displaying the measured value. If measured value is over then bar will not show new value.